Submission
X
Advanced Search
Volume 3 Issue 3
Sep.  2019
Turn off MathJax
Article Contents
Abstract
References

CEPC positron source design

  • Key Laboratory of Particle Acceleration Physics and Technology, Institute of High Energy Physics, Chinese Academy of Sciences, Beijing, China

Funds: 

The authors would like to thank all the CEPC group members for their valuable suggestions and comments. This study was supported by National Key Programme for S&T Research and Development (Grant No. 2016YFA0400400), National Natural Science Foundation of China under Grants 11705214 and Youth Innovation Promotion Association CAS.

More Information
  • Received Date: November 11, 2018
  • Revised Date: March 10, 2019
  • Accepted Date: March 24, 2019
  • Available Online: October 17, 2022
  • Published Date: April 08, 2019
    Abstract
  • PurposeCircular Electron Positron Collider (CEPC) is a 100-km-ring e+ e- collider for a Higgs factory. The injector is composed of a 10-GeV Linac and a 120-GeV Booster. The CEPC Linac is a normal conducting S-band Linac with frequency of 2860 MHz providing electron and positron beams at an energy up to 10 GeV with 100 Hz repetition frequency. The positron source is the most important part of the CEPC Linac, and the bunch charge of positron beam within some cut-off condition should be larger than 3 nC.
    MethodsThe positron source of CEPC is composed of a target, a flux concentrator, a capture section, a pre-accelerating section and a beam separation system. Higher positron yield and capture efficiency are the design goal. Based on simulation, the design will be presented and discussed in detail.
    ResultThe positron yield at the PSPAS exit is larger than 0.55, and the normalized rms emittance is 2370 mm-mrad with a strict cut-off condition. The detailed simulation results will be presented.
    ConclusionsThe design of the positron source including positron production and capture will be presented and can meet the requirements.
    • FullText(HTML)
    • References (12)
  • [1]
    Y.F. Wang, in A proposal on ring-based Higgs factory in China, 2nd Symposium on Accelerator-based HEP Strategy and Development in China, Beijing, 2012
    [2]
    Y.F. Wang, CEPC Status and Perspective, FCCWEEK2018 (Netherland, Amsterdam, 2018)
    [3]
    J. Gao, in CEPC-SPPC ACCELERATOR STATUS, Proceedings of RuPAC2016, St. Petersburg, Russia, 2016
    [4]
    Dou Wang et al., 100 km CEPC parameters and lattice design. Int. J. Mod. Phys. A 32, 1746006 (2017)
    [5]
    Tianjian Bian, Jie Gao, Xiaohao Cui, Chuang Zhang, Nonlinear dynamic optimization of CEPC booster lattice. Radiation Detection Technology and Methods 1, 22 (2017)
    [6]
    CEPC Study Group, CEPC Conceptual Design Report, IHEP-CEPC-DR-2018-01, arXiv:1809.00285, 2018
    [7]
    C. Meng, et al., CEPC LINAC DESIGN AND BEAM DYNAMICS, in Proceedings of IPAC2017, Copenhagen, Denmark, 2017
    [8]
    I. Chaikovska, et al., in Positron source, FCCWEEK2017, Berlin, Germany, 2017
    [9]
    FCC Study Group, in The Lepton Collider (FCC-ee) Conceptual Design Report, CERN-ACC-2018-0057, 2018
    [10]
    G4beamline User’s Guide (2018), http://www.muonsinternal.com/muons3/g4beamline/G4beamlineUsersGuide.pdf
    [11]
    FLUKA manual (2018), http://www.fluka.org/content/manuals/online/INDEX-fluka2011.html
    [12]
    L. Zang, T. Kamitani, in Superkekb Positron Source Target Protection Scheme. Proceedings of IPAC2013, Shanghai, China
    • Related Articles
  • Cai Meng, Xiaoping Li, Guoxi Pei, et al. CEPC positron source design[J]. Radiation Detection Technology and Methods, 2019, 3(3): 32-32. DOI: 10.1007/s41605-019-0110-6
    Citation: Cai Meng, Xiaoping Li, Guoxi Pei, et al. CEPC positron source design[J]. Radiation Detection Technology and Methods, 2019, 3(3): 32-32. DOI: 10.1007/s41605-019-0110-6
    shu
    Supplements (0)

Catalog

    Get Citation
    PDF
    XML
    Article views (3) PDF downloads (0) Cited by()

    Contact Us

    • LinksView All

      WeChat

      WeChat

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return